Chapter 2 Avaya P330-ML Layer 2 CLI Commands
set port security
User level: supervisor
Use the set port security command to enable MAC security on a port or a range of ports at the module level. The port security is activated only after you enable the secutity mode at the stack level using the set security mode command.
The syntax for this command is:
set port security { enable disable } [<module>[/<port>]]
enable disable | Set the port security enable or disable |
module/port | The switch number/the port number |
Example: |
|
P330-1(super)# set port security enable 1/2
Port 1/2 secured.
set port spantree cost
User level: privileged, supervisor.
Use the set port spantree cost command to set the cost of a port. This value defines which port will be allowed to forward traffic if two ports with different costs cause a loop.
The syntax for this command is:
set port spantree cost [module/port] [autovalue]
module/port | Module number/port number. |
auto | Spantree cost is calculated according to the standard |
value | Number representing the cost. The cost level can be set |
| from 1 to 65535 / 200000000 in STP / RSTP, respectively. |
| A lower cost (lower value) specifies precedence of a port |
| to forward traffic. |
Example: |
|
P330-N>set port spantree cost 4/2 4096
port 4/2 spantree cost is 4096
100 | Avaya |
