Avaya P330-ML-ML P330-N#set intelligent-multicast router-port-pruning-time, Set interface inband

Chapter 2 Avaya P330-ML Layer 2 CLI Commands

Example:

P330-N#set intelligent-multicast router-port-pruning-time 40

Done!

set interface inband

User level: privileged, supervisor.

Use the set interface inband command to configure the Management inband interface on the Master agent in the stack.

The syntax for this command is:

set interface inband <vlan> <ip_addr> <netmask>

vlan	The number of the VLAN to be assigned to the interface
ip_addr	IP address of the inband interface
netmask	Subnet mask

Example:

To configure the inband interface on VLAN 1, IP address 1.1.1.1 and netmask 255.255.255.24:

P330-N#set interface inband 1 1.1.1.1 255.255.255.24

Interface inband IP address set.

You must reset the device in order for the change to take effect.

set interface ppp

User level: privileged, supervisor.

Use the set interface ppp command to configure the Master agent PPP interface IP parameters, exit modem mode, disconnect the PPP session, or reset the connected modem.

You must configure an IP address and net-mask for the P330-ML before you can establish a PPP connection. The IP address is a dummy address that is shared between two peers, and must be taken from a subnet that is different from the agent’s inband IP subnet.

68 Avaya P330-ML Reference Guide