4. Product and c omponents

Back layout of the Base Unit

Atthe back of the Base Unit you can find the rocker switch, the label, the ports and connectors of the Base Unit.
1 2 3 4 5 6 7 8 9 10 1
Image4-4
Backsideof the Base Unit
1Fixture pointsfor the antenna
2Labelcontaining the article number and power rating of the product
3 Mains power connector
4Rockerswitch
5DVI-I display connector
6 DisplayPort connector
7LAN Ethernet connection
84 USB ports
9 Audio In port
10 Audio Out port

Rocker switch

The rockerswitch is used to power on and off the Base Unit.
• ToswitchontheBaseUnit,setthero
cker switch to “I”.
• To shut down the system, set the rocker switch to “0”.

Mechanicalfixture points

Them echanical fixturepoints are located at the bottom of the Base Unit

Antenna

Twoantennas are included in the ClickShare box. To avoid damage during transport, they are not pre-mounted. Depending on the
installationmethod you should secure the antenna to the back of the Base Unit or to the front panel of the rack mount.
The antennas can rotate for a better wireless connection.
Usageof antennas other than the ones provided with the unit are allowed within the restrictions on usage of other antennas defined
bylocal regulations. Barcodoes not take responsibility for damage or disturbance of other devices that may be caused by using a
differentantenna. The use of an active power amplifier is not allowed.
Antenna type : Dipole
Gain : Maximum 2dBi peak gain in 2.4GHz and 5Ghz band

Ventilation grids

Ventilationgrids are foreseen on the top and both sides of the Base Unit.
18 R5900006 CLICKSHARE 04/12/2013