DS62-Network, DS62-MD4 Network/Modem Host Module
Radius Configuration
Radius is used to authenticate logins for the serial and the network ports if passwords and user names are enabled on the DS. If the Radius server rejects either the username or password or does not respond, the DS will display “Invalid Password”.
TACACS Configuration
TACACS can be used to authenticate logins for the serial port, the network port, and modem. When a telnet / SSH session (or rs232 session) is started the Host module will prompt for the username and password. The Host will communicate with the TACACS server. If the server verifies the username and password, the Host will display the menus. If the server rejects the username and password or does not respond the Host will display the reason why the login failed.
Network Port Configuration
IMPORTANT: For network access, enable Telnet and configure the IP addresses, Subnet Mask, and Gateway Address, or enable the DHCP. The module must be reset for network changes to take effect.
Figure 5
Network setup : | 00:C0:48:00:01:FD | |
Ethernet Address | ||
IP Address |
| 70.150.140.89 |
Subnet Mask |
| 255.255.255.224 |
Default Gateway |
| 70.150.140.65 |
Connection Inactivity Timeout (mins): Disabled | ||
Carriage Return Translation: Enabled |
| |
Break Length (msecs): 350 |
| SSH is Enabled |
DHCP is Disabled Telnet is Enabled | ||
SSH host keys are set to factory default | ||
IP Address | 1 |
|
Subnet Mask | 2 |
|
Gateway Address | 3 |
|
Inactivity Timeout | 4 |
|
Carriage Return Translation | 5 |
|
Break Length | 6 |
|
DHCP Enable/Disable | 7 |
|
Telnet Enable/Disable | 8 |
|
SSH Enable/Disable | 9 |
|
SSH Host Key Generation | 10 |
|
IP Filter Configuration | 11 |
|
SNMP Configuration | 12 |
|
Web Server Configuration | 13 |
|
Exit | X,CR | |
Enter Request : |
|
|
|
|
|
11
