DS62-Network, DS62-MD4 Network/Modem Host Module
Accept changes ? (Y/N) :y
Changes accepted.
Unit Configuration Menu
The configuration menu allows the admin user to establish the parameters the
Configuration |
|
|
DS62 | module #1 | 1 |
DS74 | module #2 | 2 |
| module #5 | 3 |
Enter Request : |
|
|
Select the number of the host module and the following menu is displayed:
Copyright(C) Bay Technical Associates 2006 |
| |||
|
|
| ||
Revision F 2.10.05 | Module 1 | 509 | colilo version 1.05.01 | |
Hardware 1.01 | Serial number | |||
Status | 1 | Current setting of the module | ||
Serial Port Configuration | 2 | Setup the port configuration menu | ||
Serial Port Device Name | 3 | Name the port | ||
Attention Character | 4 | Pressing the attention character 5 | ||
|
|
| consecutive times will return back to the | |
Disconnect Timeguard | ............ | 5 | main menu. | |
| If more data is received within the delay | |||
|
|
| period, the DS series treats the | |
|
|
| character as data, not an attention | |
|
|
| character; thereby preventing unwanted | |
Connect Port ID Echo | ............ | 6 | port disconnection. | |
| Enable port echo by name or module&port# | |||
Login Setup | 7 | Login menu Access/Users/Direct Port | ||
Network Port Configuration | 8 | Connection/Radius/TACACS | ||
Network Setup IP Address | ||||
Module Name | 9 | Enter a name for the module | ||
DS Management | ..10 | Set up Voltage/Current/Sensor thresholds | ||
Firmware / Config Download | 11 | Updates by FTP & Reset to Factory Config | ||
Exit | X,CR |
|
| |
Enter Request : |
|
|
|
|
Configuration Status
The Status menu displays the modules installed and the current configuration of the host module. The following are the factory default settings:
15
