DS62-Network, DS62-MD4 Network/Modem Host Module
Network setup : | 00:C0:48:00:01:FD | |
Ethernet Address | ||
IP Address |
| 70.150.140.89 |
Subnet Mask |
| 255.255.255.224 |
Default Gateway |
| 70.150.140.65 |
Connection Inactivity Timeout (mins): Disabled | ||
Carriage Return Translation: Enabled |
| |
Break Length (msecs): 350 |
| SSH is Enabled |
DHCP is Disabled Telnet is Enabled | ||
SSH host keys are set to factory default | ||
IP Address | 1 |
|
Subnet Mask | 2 |
|
Gateway Address | 3 |
|
Inactivity Timeout | 4 |
|
Carriage Return Translation | 5 |
|
Break Length | 6 |
|
DHCP Enable/Disable | 7 |
|
Telnet Enable/Disable | 8 |
|
SSH Enable/Disable | 9 |
|
SSH Host Key Generation | 10 |
|
IP Filter Configuration | 11 |
|
SNMP Configuration | 12 |
|
Web Server Configuration | 13 |
|
Exit | X,CR | |
IMPORTANT: For network access, you must configure the IP addresses, Subnet Mask, and Gateway Address. The module must be reset for network changes to take effect.
IP Address
The IP address is the network address assigned by your network manager for your network. The IP Address consists of four bytes, each byte ranging from 0 to 255. This parameter must be programmed before the DS is accessible via the network.
Select 1) to enter the IP Address. Failure to enter the address in the decimal form causes the DS to display the following until it is entered correctly. Default Module IP Address is 0.0.0.0.
Enter IP address in dotted decimal form :
NOTE: There should be no active connections while configuring the DS module. The unit should be reset upon completion of configuration.
Subnet Mask
The Subnet Mask is a bit mask that identifies the network portion of the IP address, allowing the DS to determine whether to send a packet directly to the client or to a gateway. The Subnet Mask consists of four bytes, each byte ranging from 0 to 255. This parameter must be programmed before the DS- Series can be accessed through the network.
28
