Bay Technical Associates DS Series Main Screen, DS62-MD4, Detail Operations and Configurations

DS62-Network, DS62-MD4 Network/Modem Host Module

Detail Operations and Configurations

NOTE: Depending on the DS-Series model, the menus may vary according to the number of DS74 modules installed in the unit. If this is not an initial set-up and Password has already been enabled, you are prompted to login. After logging in successfully, invoke the main menu by sending the attention character five times (;;;;;).

NOTE: Password feature is case sensitive. Default is ‘root/baytech’.

Main Screen

DS62-MD4

IMPORTANT: The Factory default serial communications parameters are 9600 bps, 8 data bits, 1 stop bit, and no parity.

With a proper connection to the unit upon power-up or unit reset, the following initialization and Status menu will be displayed except the number of outlets will be dependent on the specific DS unit:

DS-Series - F 2.10.05	(C) 2005 Bay		Technical Associates
Module Name: DS62-MD4
Module: 1
Attention Character: ;		1
Device A	(2 ,1)
Device B	(2 ,2)	2
Device C	(2 ,3)	3
Device D	(2 ,4)	4
DS-RPC	(5 ,1)	5	Current configuration
Status		S
Configure		C	Make Changes
Unit Reset		RU	Resets the DS-Unit, terminates internal &
			external modem connections, allow 10
Logout		T	seconds for reset.
Enter Request :c

NOTE: Only the Administrator user will see the configuration option.

IMPORTANT: If you get the following message after selecting the ‘Configure’ option, the other port has the configuration option selected.

Configuration mode in use.

IMPORTANT: Once you make a change to any of the Configuration options, you have to back out of the Configuration menu and will be asked to ‘Accept’ changes. If you type ‘Y’ for YES and press <cr>, the changes take effect immediately for the serial port. For the Ethernet port you must do a Unit Reset to get the changes to take effect.

14