Bosch Appliances 500 user manual Navigating the Menus

22 en Navigating the MenusMIC Series 500 Camera

5 Navigating the Menus

The MIC 500 Series Camera is programmed through the on-screen display (OSD) menus. Each displays a list of parameters or submenus that you can select. To access the main menu, use one of two (2) methods:

–PC-based control system where you must identify preset command 85.

–Manual control via a compatible joystick

If the control system does not support presets or is limited to a preset number less than 85, tilt the unit upward until it hits the mechanical stop point, and then hold the joystick for approximately 10 seconds. The menu appears. To access the main menu via manual control:

1.Press Shot + 85 + Enter (Bosch controller). The main menu appears.

2.If this is the first time that you are using the camera, or if it is locked, you must enter the password to access all menu options.

3.Move the joystick down to ENTER PASSWORD, then move it to the right to enter the sub- menu. PASSWORD “0000” appears.

4.Move the joystick to the right. The “0000” turns green and the first number starts to blink.

5.Move the joystick up to change the first “0” to a “1”. The password should now be “1000,” which is the only valid password and can never be changed.

6.Move the joystick to the left to exit the menu. PASSWORD VALID appears.

–Tips to remember when navigating throughout the menus via the control:

–If the menu receives no manual controls for three (3) minutes, it automatically closes, returning the camera to its previous state. Any settings not saved are lost.

–Menu items appear in white, with the current item highlighted in either blue or green. If a line is highlighted in blue, use the up and down commands to move through the menu. If the line is highlighted in green, use the up and down commands to scroll through the settings for that option.

For numbers, move the joystick up to increase the numbers, and down to decrease the numbers. Move the joystick left and right to move between numbers.

–A right command can do one of two things: Move into the current option displaying all the options available, or select the current option by changing from blue to green, allowing the user to select a new value for this setting.

–A left command goes back a menu level or sets the setting that you just modified.

–Up and down commands scroll through the list and right to move into the next level of the menu. Pressing right on EXIT turns off the menu.

–For some menu items there are slight differences. For example, the Set-up Tour and Sony Set options from the main page request a number before moving into the settings. This sequence is: Select SETUP TOUR, then send right. Use the up and down to move between tour numbers, and then right again to enter the tour sub menus. The contents of the first screen is dependent on the level of user access defined by the installer under the password locked section of the menu.

MAIN MENU 1/2

MIC SETUPS

ACTIVATE FEATURE

PRESET TOUR

PATTERN TOUR

PRESETS

COMMUNICATIONS

ADVANCED SETUPS

ALARMS

MAIN MENU 2/2

SONY SET

CAPTIONS

PRIVACY

POT TEST

MIC INFORMATION

SET USER ACCESS

HELP

EXIT

F.01U.173.601 2.0 2010.11 User’s Manual Bosch Security Systems, Inc.