Bosch Appliances 500 Alarms Menu, Aux Number, Function, Menu Item, Description, Options

34 en Navigating the MenusMIC Series 500 Camera

Aux Number	Function
1	Auto Focus
2	Digital Zoom
3	Auto Iris
5	Wiper
6	Washer
7	OSD
8	Backlight

To change a mapping, select the auxiliary number from the 8 available, press right to select, sand then scroll through the available functions using up and down control inputs.

5.8 Alarms Menu

The Alarms menu allows you to turn on and off alarm-related settings, learn alarm positions, and set the status of the two (2) alarm relays.

Learn alarm pos reacts differently depending on the current alarm mode. If Auto Alarm is on and Multi Alarm is off, this function saves the single Alarm Pos, which would be activated if the tamper switch is triggered. If Multi Alarm is on, you can select which alarm position to save by selecting Right, toggling up and down to the desired number, and then Right again to save.

A MIC power supply has a single tamper switch / alarm input built in; however, if more are required, a multi alarm plug-in board with 8 inputs and a washer drive function is available. Along with the 8 inputs, the multi alarm card also features 2 output relays, which can be used to either reset the activated alarm, or provide a signal to some other equipment.

The following settings control the behavior of the MIC 500 Series Camera as it detects different alarm signals.

MAIN MENU 1/2

MIC SETUPS

ACTIVATE FEATURE

PRESET TOUR

PATTERN TOUR

PRESETS

COMMUNICATIONS

ADVANCED SETUPS

ALARMS

..ALARMS..	1/2
AUTO ALARM OFF
MULTI ALARM	OFF
ALARM REARM	60 S
MANUAL CONTROL
LEARN ALARM POS
RELAY 1 STATUS
SET WITH ALARM	1-4
NORMALLY CLOSED

..ALARMS..2/2

RELAY 2 STATUS: SET WITH ALARM 5-8

NORMALLY CLOSED

Menu Item	Description	Options
AUTO ALARM	Enables use for both single or multi alarm functionality. With Auto Alarm	ON/OFF
	on and Multi Alarm off, the unit monitors the tamper switch line, moving
	to the programmable Alarm Position when the connection is grounded.
	If Auto Alarm is turned off, the camera ignores any changes in the status
	of the tamper line.
MULTI ALARM	Enables you to set up a separate position for each of the eight (8) alarm	ON/OFF
	inputs. Any given alarm input triggers the camera to move to the
	position to which it is associated. To enable this function, turn on Auto
	Alarm and Multi Alarm.
ALARM REARM	See Section 5.8.1 Alarm Relays and Re-arm Time, page 35.	1/5/10/60 sec.

F.01U.173.601 2.0 2010.11 User’s Manual Bosch Security Systems, Inc.