Bosch Appliances 500 user manual 6Communications Menu, Manual Control

30 en Navigating the MenusMIC Series 500 Camera

5.5.3	Manual Control
	The MANUAL CONTROL feature enables the user to manually control the unit for ten (10)
	seconds while setting a preset position. A time remaining caption counts down at the top of
	the screen. At the end of the countdown, the unit stops in its current position. If more
	movement is required, press right on the Manual Control. This allows the user an additional
	ten (10) seconds of manual control.

5.6Communications Menu

The communications page provides the selection of the MIC Address, Protocol and Baud Rate. Once modified, the settings only take effect once the menu has been exited and the confirmation page has been accepted. The address field allows values in the range 1 to 254, this will be carried over between protocols.

The MIC 500 Series Camera provides twin protocol support in one release of software. The camera's operating protocol can be switched using the Cam-set or the “Protocol” setting in this menu section. The protocol pack options are: FV/Bosch (default), FV/Pelco and FV/VCL.

MAIN MENU 1/2

MIC SETUPS

ACTIVATE FEATURE

PRESET TOUR

PATTERN TOUR

PRESETS

COMMUNICATIONS

ADVANCED SETUPS

ALARMS

..COMMUNICATIONS..

ADDRESS	1
PROTOCOL	BOSCH
BAUD RATE
-------------------------------------------
: WARNING CHANGING :
: ANY SETTING MAY		:
: CAUSE A LOSS OF		:
: CONTROL		:

Menu Item	Description
ADDRESS	Allows the appropriate camera to be operated via the numerical address in the control system. The
	address may be set locally using Cam-set. To change the address using Cam-set, enter the desired
	address in the New Address field then, press Configure MIC Communications. The MIC
	Communications Settings menu is displayed. Modify the settings then, press Apply (optional 1-254
	addresses).
PROTOCOL	Enables the user to switch between the protocols in the loaded protocol pack. Options are: FV/
	Bosch (default), FV/Pelco or FV/VCL.
BAUD RATE	Enables the user to toggle between 4800 and 9600 Baud rate. The speed at which
	telecommunication data is transmitted, measured in bits per second (Bps).
	The “Baud Rate” setting provides a full range of values, 1200, 2400, 4800, 9600, 19200 or
	38400 for each protocol. Not all protocol controllers support this full range, so ensure that the
	correct option is selected before confirming.
	Modifying any of these parameters and then confirming the selection causes immediate loss
	of control until the control system is reconfigured to match. If a protocol, address or baud
	rate option is made that cannot be obtained through the control system, the camera must be
	reset using the Configure MIC Communications function of Cam-set.
	Modifying any of these values invokes an extra page to appear when exiting the menu. To
	accept the changes made, move the line down to APPLY SETTINGS and press right. To ignore
	them, press right on DISCARD SETTINGS.

F.01U.173.601 2.0 2010.11 User’s Manual Bosch Security Systems, Inc.