Bosch Appliances 500 user manual Help Menu, 16Self Diagnosis, Support USA, Emea, Asia

50 en Navigating the MenusMIC Series 500 Camera

Setting	Default Value
Tour (Step : Preset : Dwell)	1 : 1 : Default
	2 : 2 : Default
	3 : 3 : Default
	4 : 4 : Default
	5 : 5 : Default
Sony Set Table 1 Mapped To	Normal
Sony Set Table 1	Auto Focus, Auto White Balance,
	Auto Exposure, Effect Off
Sony Set Table 2 - 10 Mapped To	Nothing
Sectors	Cleared

5.15	Help Menu
	The Help Menu provides users information on where to get additional help.

MAIN MENU 2/2

SONY SET

CAPTIONS

POT TEST

MIC INFORMATION

SET USER ACCESS

HELP

EXIT

a

..HELP..

WEBSITE WWW.BOSCHSECURITY.COM

SUPPORT
USA	1 888 289 0096
EMEA	131 40 2577 284
ASIA	65 6319 3450

5.16Self Diagnosis

Self diagnosis runs basic tests indicating any faults with the unit. There are three ways to initiate the test: a Go To preset 86 command; the last option under MIC Setups on the On- Screen Menu; and the camera can self-start the test on boot if the user loops the telemetry to itself (TxA to RxA, and TxB and RxB). On a system where there may be a communication issue, the last option is likely to be the best. This should be checked directly at the PSU first and then in the control room, as there may be a fault in the setup between the two not allowing the MIC to talk to itself.

Running a Self Diagnosis Test

The MIC 500 Series Camera moves to a specified test position, then checks for valid resolver readings and reliable camera module communications. Then, the camera tests the pan and tilt drives and camera zoom. Finally, it activates the wiper (seen from the pole base or on the video). The results of each test are displayed as they are completed. If all of the tests pass, but the camera still does not work properly, there may be a problem elsewhere in the system. If any faults are detected, call the manufacturer for assistance.

F.01U.173.601 2.0 2010.11 User’s Manual Bosch Security Systems, Inc.