D1260/D1260B Owner's Manual Part II: System Commands - MASTER ARM ? (COMMAND + 1)
MASTER ARM ? (COMMAND + 1)
Description
Use this function to turn on the entire system, both perimeter and interior. When you turn on the system, the display shows how many seconds of exit delay time you have to exit the protected area. You should leave before exit delay time expires.
Leaving after exit delay has expired will cause the entry delay to start. You may also cause an alarm on an interior device. Enter your personal passcode to disarm the system.
This function may be used by your cleaning service, a serviceman, or others who need to turn on your system when they leave.
Using Master Arm:
Using the COMMAND +1 shortcut will only arm the area where the keypad has been assigned. Example, if the D1260 is assigned to Area 1, only Area 1 will be armed when COMMAND + 1 is pressed.
1.The display shows disarmed idle text.
2.Press the COMMAND key.
3.The display shows *System Command*.
4.Press the 1 key
5.If your system is programmed to require a passcode when performing a COMMAND 1, the display prompts you to enter your passcode.
The passcode is shown as asterisks (*).
6.If the passcode has valid authority for this command, the display shows Exit now # (# = exit delay time remaining) seconds remaining.
After the exit delay time expires, the display changes to idle armed text.
7.To disarm your security system, enter your personal passcode and press ENTER.
Bosch Security Systems 9/04 50410D | 19 |
