D1260/D1260B Owner's Manual Part IV:
MOVE TO AREA ? (COMMAND + 5 + 0)
With this function you can perform tasks in an area other than the one you’re in without having to physically go to that area. Your access to other areas is limited by the scope of the command center and your authority level. For example, if your passcode gives you authority to all 8 areas, but the command center you’re working with is limited in scope to areas 1 and 2, then you will only be able to move to either area 1 or area 2.
Upon moving to another area, the range of tasks you may perform depends upon the command center you’re working with. Once you’ve performed a task (such as Turning the Area On), the command center reverts back to its programmed area after 10 seconds. Thus only one task can be performed in another area at a time.
1.Ensure your keypad shows idle disarmed text.
2.Press the COMMAND key. The display shows *System Command*.
3.Press the 5 key and then the 0 key.
If you prefer, you may use the Command Menu in place of steps 2 and 3 to initiate this function.
Press the MENU> soft key to enter the
Command Menu.
Press NEXT> soft key repeatedly.
When you reach the MOVE TO AREA ?> prompt, press its adjacent soft key.
4.You may be prompted for your passcode. If so, enter your passcode and press the ENTER key. It will appear on the display as asterisks (*).
The <Exit soft key will quit this function and return to idle text.
5.The command center will then display the Area Name Text of each area that falls within the scope of the command center and authority level of the user, if applicable. (All 8 area names are shown as an example).
If the user's authority level does not permit access to a certain area and that area is not within the scope of the command center, or the area is not enabled, it will not appear in the display.
If the area you wish to move to does not appear in this list, press the Next> key to display additional areas.
To select an area, simply press the soft key corresponding to the Area Name.
6.Moving to…AREA 1 WAREHOUSE displays briefly, and then the text of the area you’ve moved to is displayed (AREA 1 WAREHOUSE is used as an example here).
70 | Bosch Security Systems 9/04 50410D |
