D1260/D1260B Owner's Manual Part III: Advanced Commands -
2.Press the COMMAND key. The display shows *System Command*.
3.Press the 5 key and then the 9 key.
If you prefer, you may use the Command Menu in place of steps 2 and 3 to initiate this function.
Press the MENU> soft key to enter the
Command Menu.
Press NEXT> soft key repeatedly.
When you reach the DISPLAY REV ?> prompt, press its adjacent soft key.
4.The display will change to Radionics D9412* Version
(D9412 and
5.The display will return to idle text after 5 seconds.
SERVICE MENU ? (9 + 9 + Enter)
The service menu is used to access the following commands:
•View Log - Use this function to review events in your system at your command center. Reviewing past events may help you identify problems.
Viewing events does not require any additional equipment since the information is displayed at your command center. Events are stored in the panel’s memory in order of occurrence and tagged with the date and time.
•Print Log - The Print Log function lets you print the events stored in your security system’s log. You can choose to print the entire log or set a start date and print the events recorded from that date up to today. Your system must include a parallel printer interface and a printer to perform this function.
•Display Rev (COMMAND + 5 + 9) - The command will retrieve the panel’s software version and display it.
•Service Walk (D9412/D9112 only) – The command will allow all the points on the system to be walk tested regardless of the type of point. For D7412 and D7212 panels this function must be added to the keypad’s menu. Contact your security company for more information.
•Default Text – This command will show the current state of the area for 3 seconds before returning to idle text.
1.Ensure your keypad shows idle disarmed text.
2.Press the 9 key twice.
3.Press the ENTER key.
4.The display changes to show the service menu.
Service Walk Test?> appears on D9412/D9112
Panels only
Bosch Security Systems 9/04 50410D | 63 |
