D1260/D1260B Owner's Manual Part II: System Commands - RESET SENSORS ? (COMMAND + 4 + 7)
RESET SENSORS ? (COMMAND + 4 + 7)
Reset Sensors
Description
Detection devices, such as smoke detectors and shock sensors, must be reset after being activated. This function momentarily removes power from these sensors to reset them.
It also clears point information from the display, leaving the *ALARM SILENCED* message in the display as a reminder that the View Memory function can be used to view the cleared point information.
To clear the event memory and remove the *Alarm Silenced* message from the display, press the Clear Display> soft key.
The display will show the instructions for clearing the message. Enter a valid passcode and press the Clear> soft key.
Arming the system will also clear the display and the event memory.
Using Reset Sensors:
1.The display shows disarmed idle text.
2.Press the COMMAND key. The display shows *System Command*.
3.Press the 4 key, followed by the 7 key.
If you prefer, you may use the Command Menu in place of steps 2 and 3 to initiate this function.
Press the MENU> soft key to enter the
Command Menu.
Press NEXT> soft key repeatedly.
When you reach the RESET SENSORS ?> prompt, press its adjacent soft key.
Press ENTER.
4.The display shows for approximately 15 to 20 seconds.
The display then shows retrieving the panel information.
The display then returns to show idle text.
If you enter this function and the detector or sensor resets momentarily, but then returns to a faulted condition, the conditions causing the activation may still be present or the detector may be faulty. Check to be certain that there is no smoke, fire, or other danger present. If you can’t reset the detector or sensor contact your security company.
Bosch Security Systems 9/04 50410D | 27 |
