3. FUNCTION SETTINGS
3-2. List of memory switch settings
Memory switch No. 0 - 15No. | Initial value | Setting range | Setting details |
| |
|
|
| Needle up stop position setting |
| |
0 | 0 (degrees) |
|
| ||
(degrees) | Higher | Lower | |||
|
| ||||
|
|
| |||
|
|
|
| 0212B | |
|
|
|
|
| |
|
|
| Needle down stop position setting |
| |
1 | 0 (degrees) |
|
| ||
(degrees) | Higher | Lower | |||
|
| ||||
|
|
| |||
|
|
|
| 0212B | |
|
|
|
| ||
|
|
| Depressing treadle forward when treadle is depressed backward (thread | ||
2 | 0 | 0 - 1 | trimming) |
| |
0: Disabled (Enabled after treadle is returned to neutral position and then | |||||
|
|
| depressed forward) |
| |
|
|
| 1: Enabled |
| |
3 | 1 | 0 - 1 | Power supply voltage drop check (reset detection) function | ||
0: None |
| ||||
|
|
| 1: Enabled, [Err 95] displayed when voltage drops. |
| |
4 | 0 | 0 - 1 | Buzzer (electronic sound) during panel operation |
| |
0: Yes |
| ||||
|
|
| 1: None |
| |
5 | 0 | - | [Do not change this setting.] |
| |
6 | 0 | 0 - 1 | Piercing force boosting operation |
| |
0: Yes |
| ||||
|
|
| 1: None |
| |
7 | 0 | 0 - 1 | End backtacking speed |
| |
0: Limited by speed bar key setting |
| ||||
|
|
| 1: Not limited by speed bar key setting |
| |
9 | 0 | 0 - 1 | End backtacking sewing speed |
| |
0: Speed can be set independently from start backtacking speed | |||||
|
|
| 1: Speed is set to start backtacking speed |
| |
|
|
| Presser foot condition when treadle is returned to neutral position after | ||
12 | 0 | 0 - 1 | thread trimming |
| |
0: Presser foot is lowered (it is not lowered when DIP switch 1 is OFF) | |||||
|
|
| |||
|
|
| 1: Presser foot is not lowered |
| |
13 | 0 | 0 - 1 | Presser foot condition when operation stops at the neutral treadle position | ||
0: Presser foot is not lifted |
| ||||
|
|
| 1: Presser foot is lifted |
| |
|
|
| Actuator function |
| |
14 | 0 | 0 - 1 | 0: Operates as a reverse stitch switch during sewing, and as a correction | ||
stitch switch when sewing is stopped |
| ||||
|
|
|
| ||
|
|
| 1: Thread trimming switch |
| |
15 | 0 | 0 - 1 | Deceleration stop control when treadle is returned to neutral position | ||
0: Deceleration stop control without single stitch advance |
| ||||
|
|
| 1: Above control is not carried out |
| |
4 |