10. APPLYING GREASE (When “GrEASEUP” appears)
|
|
|
|
| Use the tip of a long brush or similar to | 2. Apply approx 1g |
|
| apply approx 1g of grease to the places |
| |
| indicated by arrows [E] to [G]. | of grease. |
|
|
| 1. Pull the needle bar (3) |
|
|
| forward with your finger. |
|
|
| 3. Turn the machine pulley to gently |
|
|
| apply the grease onto the felt. |
|
|
| Felt |
|
| After applying approximately 1g of grease to | 4. Move the needle bar (3) back and |
|
| the groove, move the needle bar (3) back and | forth with your finger to spread |
|
| forth with your finger to spread the grease. | the grease. |
|
|
|
|
|
|
| 3488M | |
After applying grease in the places indicated by arrows [A] to [G] above, carry out the reset operation described below.
10-3. Resetting the cumulative operating time
After the grease has been applied, carry out the following procedure to reset the cumulative time between grease applications.
1. Turn the power switch to “ON”. “GrEASEUP” will flash in the main display (1) and the buzzer will sound.
2. Press the RESET key (2). The main display (1) will switch to zigzag width/zigzag base line position display mode.
3. Press and hold the LOCK key (4) for 2 seconds or more.The lock icon (5) will switch off and the lock will be released.
4. Press the FUNC (Function) key (6). “n.134 xxx” will appear in green in the main display (1).
(xxx represents the time between grease applications.)
5. Press the rightmost key (7). The “ 
” will change to “0”.
6. Press and hold the ENTER key (8) for two seconds or more.
A long beep will sound and the main display (1) will switch to zigzag width/zigzag base line position display mode.
7. Depress the treadle to run the sewing machine for 1 second or more.
8. Turn the power switch to “OFF”. (This completes the reset procedure.)
3489M
87 |