|
| 9. ADJUSTMENTS | |
|
|
| |
|
| ||
|
| The safety switch (1) is normally installed as shown in figure | |
| 3801M | ||
|
| [A]. | |
|
| However, if the processing method used for the table leaves | |
|
| too much space between the machine bed and the table hole, | |
|
| it may adversely affect the operation of the safety switch (1). | |
Sewing machine
The standard amount of clearance between the machine bed and the table hole is 1.5 mm.
If the clearance is 3.5 mm or more, install the safety switch
(1) so that the washer (2) is on the machine bed side as shown in Figure [B].
* If the position cannot be satisfactorily adjusted in this way, add more washers of the same thickness.
<Safety switch operation>3691M
If the spring stroke is too small, the safety switch will not operate.
3.5 mm or more
Table
Clearance is too large.
By changing the position of the safety switch, the required spring stroke can be maintained.
| Reduce the | clearance. |
3690M |
| 3692M |
68 |