Accessing LM
5.1.2Console Cable Configuration
Connect the console cable to the STHI as follows:
1.Attach the male RJ45 connector to the COM port of the STHI.
2.Attach the female end to the
5.1.3Entering LM
After configuring the LM terminal and properly attaching the cable to the STHI, the user may access the Local Management interface.
1.Activate the console: power up the terminal, or run the emulator program. After the STHI is fully booted, the STHI Password screen shown in Figure
STHI LOCAL MANAGEMENT
Cabletron Systems, Incorporated
P.O. Box 5005
Rochester, NH
(603)
(c)Copyright Cabletron Systems, Inc. 1995
Flash Image Version: 1.00.00
Boot EPROM Version: 01.00.00
Board Revision: 112
Enter User Password:
Figure
2.Enter a password. (There are two factory default passwords for
Passwords are
If the password entry is invalid, the entry is cleared and the cursor returns to the beginning of the password entry field. If the password is valid, the associated access level in effect for the session is reported briefly on the
Page