Setting the Jumpers and Loading the Configurations
To Load a Configuration File
To Load a Configuration File
There are two configuration files you will be loading. One for the analyzer CH0X._A, and one for the oscilloscope CH0X._B. For exercises that only use the analyzer, you will only load the CH0X._A file. For exercises using the scope, you will load both the CH0X._A and the CH0X._B files.
1Place the flexible disk labeled "Logic Analyzer Training Kit Configurations" in the disk drive.
2Press the System MENU key.
3Highlight the field to the right of System, then press the Select key. Choose Flexible Disk in the
If the file directory has not been previously read by the logic analyzer, you will see "reading directory . . ." before the directory listing is displayed.
4Highlight the field below the System field, on the left side of the screen, then press the Select key. Highlight Load in the
See the figure on the next page if you need help.
5Highlight the field to the right of Load, then press the Select key. Highlight Analyzer in the
The procedure for loading a configuration file continues on the next page.
6Using the knob, place the file name you want to load on the light gray center line of the display.