If you are not performing the exercises in order, you may need to load configuration files to set up your system so that you can complete the exercises. The "To Load a Configuration File" exercise on the next two pages gives you the information you need to load configuration files. The flexible disk labeled "Logic Analyzer Training Kit Configurations," which you received in this training kit, contains the configuration files. The files are listed in Table 2, below.
If you are doing the exercises for the first time, we recommend you follow the steps in each consecutive exercise, from chapter 1 through chapter 5, without loading the configuration files. If you do not want to do the exercises in order, you can load the files listed in the "Before You Begin" section of a chapter, then do the exercises in that chapter.
Table 2 | Configuration Files |
|
|
|
|
| Filename | File description |
| CH03_60._A | State Exercises |
| CH03_70._A | State Exercises |
| CH04._A | Compare Exercises |
| CH05._A | Mixed Mode Exercises |
| CH06._A | Advanced State Exercises |
| CH07._A and CH07._B | Oscilloscope Exercises |
| CH08._A and CH08._B | Oscilloscope/Timing Exercises |
| CH03_60._A | Pattern Generator Exercises |
| TRC_386._A and IA386E | Inverse Assembly for the HP 1660s |
| TRC_32._A and ICPU32 | Inverse Assembly for the HP 1670s |