Setting the Jumpers and Loading the Configurations
To Set the Jumpers
To Set the Jumpers
1Pull the appropriate jumper off of the pins of J5.
2Push the jumper onto the correct pins of J5. You only need to change jumpers that differ from the settings in table 1.
Set the jumpers at their default settings for all chapters. Table 1 shows you the default settings and the settings for each chapter. Chapter 4, "Comparing State Traces," and chapter 8, "Triggering the Oscilloscope with the Timing Analyzer," requires you to change the setting of the glitch jumper.
CLK2 P. G.
OSC
P. G.
CLK1 CLK2
GLITCH
OFF ON
Glitch OFF
CLK2 P. G.
OSC
P. G.
CLK1 CLK2
GLITCH OFF
ON
Glitch ON
J5 - Jumpers are set here.
Setting the Jumpers