Advanced State Triggering
Before You Begin
Before You Begin
1Decide what to do next.
If you have just completed all of the exercises in Chapters 2 through 5, go to "Put the Analyzer into State Mode" on the next page.
If you have not just completed all of the exercises in Chapters 2 through 5, go to step 2.
2Load the Analyzer with the configuration file, CH06._A.
The file defaults all system settings and sets up the analyzer as if you just completed all of the exercises in Chapters 2 through 5.
Unless you are using an HP 1661 or an HP 1671 analyzer, you may see an advisory message when you load the files. This is not an error. The message is displayed because these logic analyzers have a different number of data pods from the HP 1661, which was used to create the files.
3Connect Pod 1.
Connect Pod 1 of the analyzer to J1 on the Training Board. For the
HP 1660s, Pod 1 is the top cable in the
4Set the jumpers as shown below.
The jumper settings of J5 on the training board for this chapter are the same as the default settings.
CLK2 P. G.
OSC
P. G.
CLK1 CLK2
GLITCH
OFF
ON
See Also | "To Set the Jumpers" and "To Load a Configuration File" in chapter 11 for |
| more information. |