Using the Oscilloscope

Get the Waveform on the Display

Get the Waveform on the Display

The Autoscale feature automatically scales the vertical sensitivity and the horizontal time base of the oscilloscope to provide a display of the waveform. This simplifies the setup of the oscilloscope and is very helpful when the amplitude and period of a signal are unknown.

1Press the Config key.

2Highlight the field in the top, left corner of the display and press the Select key. Highlight Scope in the pop-up menu, and press the Select key.

3Highlight the Autoscale field and press the Select key. Highlight Continue in the pop-up menu, and press the Select key.

The analyzer is in scope mode.

This field initiates the

Autoscale feature.

Channel designator

Training board clock signal

 

Getting the Waveform on the Display

Result

The training board clock signal is automatically scaled and is displayed in

 

channel C1.

7-5