Triggering the Oscilloscope with the Timing Analyzer
Connect the Oscilloscope Probe
Connect the Oscilloscope Probe
1Connect the oscilloscope probe to channel 1 on the front panel.
2Connect the probe tip to the test point labeled "Glitch" on the Logic Analyzer Training Board.
Note that this is a different test point than the "CLK 1" test point that was used in Chapter 7.
3Connect the probe ground lead to the test point labeled "Ground" on the training board.
Note | Leave Pod 1 connected to J1. This provides +5 V for the training board. |
| If Pod 1 is not connected to J1, connect it now. |
J1 - Pod 1 of the analyzer connects here.
GND - Oscilloscope ground connects here.
GLITCH - Oscilloscope
probe tip connects here. Connecting the Oscilloscope Probe