Ready, Set, Run:

Easy Steps to Logic Analysis with the HP 1660/70 Series

Start Here

READY With the power off, connect Pod 1 of the analyzer to J1 on the Training Board. For the HP 1660s, Pod 1 is the top cable in the left-most position when you are facing the rear of the logic analyzer. For the HP 1670s, Pod 1 is the top cable in the right-most position when you are facing the rear of the logic analyzer.

1660 Series

1670 Series

SET Turn on the analyzer by pressing the power switch near the bottom of the front panel.

The analyzer will take about 15 seconds to boot up.

ii