Using the Oscilloscope
Connect the Channel 1 Oscilloscope Probe
Connect the Channel 1 Oscilloscope Probe
1Connect the oscilloscope probe to channel 1 on the front panel of the analyzer.
2Connect the probe tip to the test point labeled "CLK 1" on the Logic Analyzer Training Board.
3Connect the probe ground lead to the test point labeled "GND" on the Logic Analyzer Training Board.
Note | Connect pod 1 to J1 of the training board. Pod 1 must be connected to |
| supply the +5 V power for the training board. |
J1 - Pod 1 of the analyzer connects here.
GND - Oscilloscope ground connects here.
CLK1 - Oscilloscope probe tip connects here.
J5 - Jumpers are set | Connecting the Channel 1 Oscilloscope Probe |
here. |