Using the Pattern Generator
Before You Begin
Before You Begin
1Load the configuration file for chapter 3, CH03_60._A.
If you need instructions to load the configuration files, refer to chapter 11, "To Load a Configuration File."
2Connect Pod 1.
Connect Pod 1 of the analyzer to J1 on the Training Board. For the
HP 1660s, Pod 1 is the top cable in the
3Set the jumpers as shown below
The jumper setting of J5 on the training board for this chapter are the same as the default settings. For more information about setting the jumpers, refer to chapter 11, "To Set the Jumpers."
CLK2 P. G.
OSC
P. G.
CLK1 CLK2
GLITCH
OFF
ON