Introduction to State Analysis
Before You Begin
Before You Begin
1Decide what to do next.
If you have just completed the exercises in chapter 2, go to "Put the Analyzer Into State Mode" on the next page. Otherwise, continue to step 2.
2If you are using an HP 1660 series analyzer, load the Analyzer with the configuration file, CH03_60._A. If you are using an HP 1670 series analyzer, load the Analyzer with the configuration file, CH03_70._A.
For instructions on loading configuration files, see "To Load a Configuration File" in chapter 11.
The file defaults all system settings and sets up the analyzer as if you had just completed the exercises in chapter 2.
Unless you are using an HP 1661 or an HP 1671 analyzer, you may see an advisory message when you load the files. This is not an error. The message is displayed because these logic analyzers have a different number of data pods from the HP 1661, which was used to create the files.
3Connect Pod 1.
Connect Pod 1 of the analyzer to J1 on the Training Board. For the
HP 1660s, Pod 1 is the top cable in the
4Set the jumpers as shown below.
The jumper settings for this chapter are the same as the default settings.
CLK2 P. G.
OSC
P. G. J1
CLK1 CLK2
GLITCH
OFF ON
| Setting the Jumpers |
See Also | "To Set the Jumpers" and "To Load a Configuration File" in chapter 11 for |
| more information. |