Using the Pattern Generator
Connect the Pattern Generator
Connect the Pattern Generator
•Connect the pattern generator output Pod 4 to the TTL Data Pod. Then connect the TTL Data Pod to J4 (labeled PATTERN GENERATOR) on the training board.
For more information about setting the jumpers, refer to chapter 11, "To Set the Jumpers."
Note | Pod 1 of State/Timing is not only used to acquire the pattern generator’s |
| output pattern, it also provides the needed + 5V for the training board. |
Pod 4 of the pattern generator.
J4 - The TTL Data Pod, with Pod 4 of the pattern generator attached, connects to the training board here.
J1 - Pod 1 of the analyzer connects here.
Connecting the Pattern Generator