Introduction to Timing Analysis
Before You Begin
Before You Begin
1Decide what to do next.
If you have just completed "Ready, Set, Run", go to "Change a Label Name" on page
If you have not just completed "Ready, Set, Run" go to step 2.
2Turn off the analyzer by pressing the power switch. Wait at least five seconds, then press the power switch again to turn on the logic analyzer.
Cycling the power defaults all system settings. This sets up the analyzer so you can perform the remaining exercises.
3Connect Pod 1.
Connect Pod 1 of the analyzer to J1 on the Training Board. For the HP 1660s analyzer, Pod 1 is the top cable in the
4Set the jumpers as shown below.
The jumper settings of J5 on the training board for this chapter are the same as the default settings.
J1
| Setting the Jumpers |
See Also | "To Set the Jumpers" and "To Load a Configuration File" in chapter 11 for |
| more information. |