Mixed Mode - Correlation of State and Timing Data
Connect the Timing Analyzer
| Connect the Timing Analyzer |
Note | If you have a termination adapter, HP part number |
| the adapter between Pod 3 of the logic analyzer and J2 of the training |
| board, then go to the next page to put the analyzer into state and timing |
| modes. |
1Connect the Pod 3 connector to the probe assembly.
For the HP 1660s, Pod 3 is the top cable in the second connector from the left, as you are facing the back of the logic analyzer. For the HP 1670s, Pod 3 is the top cable in the second connector from the right, as you are facing the back of the logic analyzer.
Note | Leave Pod 1 connected to J1 of the training board. Pod 1 provides the |
| +5 V power for the training board. |
2Connect the probe leads 0 through 7 to the pins D0 through D7 of J2.
3Connect the probe ground lead to any pin of J3.
Probe Assembly
Pod 3 Connector
Connecting the Pod 3 Cable to the Probe Assembly