Introduction to State Analysis
Run the State Analyzer and View and Change the State Listing
Run the State Analyzer and View and Change the State Listing
1Press the Run key.
2Observe the State Listing.
The trigger pattern 00 is centered around the zero line number, which corresponds to the trigger point you specified in the Trigger menu. The negative line numbers indicate the states stored prior to the trigger point.
The line numbers show the locations of the data in the logic analyzer’s memory.
Trigger point 00
This is the state data you acquired from the ripple counter.
State Listing Menu
3Use the table below to view and change the state listing.
To Do This:
To change the state listing display from hex to decimal
To scroll through the state listing
To page through the state listing one screen at a time
Do This:
Highlight the Hex field directly below the SCOUNT label, and press the Select key. Choose Decimal from the
On the
Press the Page keys below the knob.