Canon 2010F manual Feeder ADF-J1, Neatly place your originals face up in the original supply tray

1

Introduction to Copying

Feeder (ADF-J1)

Place a stack of originals in the feeder, and press [Start]. The machine automatically scans them into memory.

You can place the following originals in the original supply tray:

•Weight: 10 to 32 lb bond (37 to 128 g/m2)

Place very thin originals 10 to 14 lb bond (37 to 51 g/m2), or very thick originals 28 to 32 lb bond (105 to 128 g/m2) into the feeder one at a time.

•Size: 11'' ✕ 17'' , LGL , LTR , LTR , or STMT .

•Tray Capacity: 50 sheets (20 lb bond [80 g/m2])

25 sheets (11 lb bond [40 g/m2] or less)

IMPORTANT

•Do not place the following types of originals in the feeder:

-Originals with tears or large binding holes

-Severely curled originals or originals with sharp folds

-Clipped or stapled originals

-Carbon backed paper or other originals which might not feed smoothly

-Transparencies and other highly transparent originals

•Avoid scanning the same original using the feeder more than approximately 30 times. Scanning the same original repeatedly may result in the original becoming folded or torn, which in turn could cause a paper jam.

•If the feeder rollers are dirty from scanning an original written in pencil, perform the feeder cleaning procedure. (See Chapter 7, “Routine Maintenance,” in the Reference Guide.)

1 Neatly place your originals face up in the original supply tray.

If you are enlarging LTR originals to 11'' x 17'' or LGL paper, place your originals horizontally.

Place your originals as far into the feeder as they will go.

Cou
Checknter
Display
Contrast
Collate
Special
Features	COPY
	FAX

A beep sounds when the originals are set correctly.

1-14Placing Originals