Carrier Access 770-0125-AB installation manual Installation

Installation

Installing OSP155/ESP155/BCP155 Line Interface Cards

2.Insert the cards into the chassis. Open the ejector tabs and slide the card into its proper slot until you feel resistance, then push to close the ejector tabs into their locking position against the metal rails. Verify that the card is firmly in place by applying pressure to the ejector tabs to seat the card fully into the chassis.

WARNING! WHEN INSTALLING OR REPLACING BROADWAY HARDWARE, ALWAYS ADHERE TO GOOD PRACTICE WITH RESPECT TO ESD PROCEDURES—USE A REGULARLY AND PROPERLY TESTED GROUNDING STRAP.

3.Dress the cables through the grommets at the right hand side of the chassis. The duplex fiber cable fits snugly in each slot.

4. Connect the other end of the fiber cables to your fiber terminating equipment.

2-26 BROADway - Release 4.00