Carrier Access 770-0125-AB installation manual Ethernet Port Command Line Access

Configuration

Management Access to the BROADway System

Ethernet Port Command Line Access

1.Connect your PC or workstation to one of the Ethernet ports (see Cabling the Ethernet Port on page 2-9) and open a Telnet session to the IP address of the BROADway system (e.g. 169.254.0.1).

2.You should be presented with the LOGIN> prompt. Use CUSTOMER for the user name and BROADWAY as the password.

3.If you are successfully logged in, you will be presented with the NSP1> or NSP2> prompt.

4.You can now configure the BROADway system using the CLI interface. Follow the instructions in Logging In With the Command Line Interface (CLI) on page 3-13to learn how to log in and out of the system using the CLI or in Setting Up User Accounts on page 3-13.

NOTE: The BROADway system supports up to three simultaneous Telnet client sessions.

Ethernet Port Web Browser GUI Access

Connect your PC or workstation to one of the Ethernet ports on the BROADway and then follow the instructions found at Logging In With the Web Browser Interface (GUI) on page 3-9.

3-8 BROADway - Release 4.00