Carrier Access 770-0125-AB PS#show BVI status bridge-group number, PS#show bvi status

Configuration

Assigning an IP Address to the BROADway System

To change the state of the BVI to “up”, use the following PS commands:

PS#configure

PS(NSP-config)#interface bvi 1

PS(NSP-config-bvi)#no shutdown

To display the status of the BVI, use the following PS command:

PS#show BVI status [bridge-group number]

If you specify an optional [bridge-group number], only the BVI associated with the [bridge-group number] will be displayed. If you leave the [bridge-group number] field blank, all of the configured BVIs will be displayed.

The following sample output shows the show BVI status command results:

PS#show bvi status

BVI is configured for this bridge group

BVI is administratively enabled

MAC address of BVI is 00-02-35-00-ca-e8

3-6 BROADway - Release 4.00