Carrier Access 770-0125-AB Cabling the BSP200, BSP200 LED Indicators, Connect BNC coaxial cables

Installation

Installing the BSP200 Line Interface Card

Cabling the BSP200

The BSP200 line interface cards use the 75Ohm BNC ports TX1/RX1, TX2/RX2, TX3/RX3, and TX4/ RX4 respectively on the top I/O panel of the BROADway chassis.

To make your DS3 cable connections:

1.Connect the DS3 inputs by connecting 75Ohm BNC coaxial cables to TX1/RX1 through TX4/ RX4.

Connect BNC coaxial cables

NIP RX1	NIP RX2	RX1	RX2	RX3	RX4	CKIN-1 CKIN-2	ETH-1	ETH-2	SCP-1
NIP TX1	NIP TX2	TX1	TX2	TX3	TX4		ALARMS	ACO	SCP-2

2. Connect the other end of these cables to your DS3 terminating equipment.

BSP200 LED Indicators

Each BSP200 line card has two LED indicators that describe the operational status of the module itself. There are a further two LED indicators per card that describe the status of the line interface.

NIP-1

	E
	L
	U
	D
M	O

13

INTERFACE

NIP-5

NSP-2

NSP-1

	E
	L
	U
	D
M	O

13

INTERFACE

2

1

ACTIVE	ALARM SUM	PWR	2	ETH
			1

UIP-2

ACTIVE				UIP-1
1	3	5	7	9 11 13 15

OSP-1

BSP-4

BSP-3

BSP-2

BSP-1

	E		E
			C
	L		A
	U	E	F
	D
	O	R
M		T
		IN

A D w a y

TM

The following tables describe the status of the BSP200 line interface card based upon the front panel LED status of the card.

MODULE Red LED	MODULE Green LED	Status
(Top)	(Bottom)
Off	Off	No power to the card
Off	On	Card operating normally
On	Off	Card failure
On	On	Card initializing during system
		power up

2-22 BROADway - Release 4.00