Chapter 3 Installing the Router
Using Flash Memory Cards in the RP
Step 4 Reboot the system.
Copying Cisco IOS Software Updates
As future releases of Cisco IOS software become available, you will receive these images as a file booted from a network TFTP server, as a file on a floppy disk, or as a file on a Flash memory card.
This section explains how to use a newly released Cisco IOS software image on a Flash memory card in a system that has an older Cisco IOS image residing on a Flash memory card inserted in PCMCIA slot 0 and a default Cisco IOS software boot image stored in the onboard Flash memory SIMM on the RP.
In this procedure, you will copy an updated Cisco IOS software image from a new Flash memory card onto a Flash memory card containing an old Cisco IOS software image. In this example, the following filenames apply:
•
•
•
This procedure assumes that there is sufficient space on the old Flash memory card inserted in slot 0 for both the new Cisco IOS software image and the old image. If there is not enough space for both images on the old Flash memory card, use the delete command to delete files from the old Flash memory card, but do not delete the image.old file. After deleting files, use the squeeze command to remove the deleted files from the old Flash memory card permanently. For information on the squeeze command, see the “Flash Memory Console Commands” section on page
If the two files still will not fit on the Flash memory card in slot 0 after you delete files and use the squeeze command, remove this card, place it in an antistatic bag for ESD protection, and store it in a safe place. Insert the Flash memory card containing image.new in slot 0. Proceed to Step 5 in the following procedure and enter the command boot system flash slot0:image.new to designate the file image.new as the new default Cisco IOS software boot image.
|
| Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide |
|
|
|
|
| ||
|
|
| ||
|
|
|
