Cisco Systems 12406, 12006 manual Router# copy startup-config slot0myfile2, Router# dir slot0

Chapter 3 Installing the Router

Using Flash Memory Cards in the RP

An example of the copy startup-config slot0:filename command follows:

Router# copy startup-config slot0:myfile2

20575008 bytes available on device slot0, proceed? [confirm] Address or name of remote host [1.1.1.1]?

Loading new.image from 1.1.1.1 (via Ethernet0):

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

[OK - 7799951/15599616 bytes]

CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC

Router#

In this example, the exclamation points (!) appear as the source file is being downloaded to the destination device. The CCCCC characters indicate that a cyclic redundancy check (CRC) is being calculated during the downloading process. The CRC verifies that the file has been correctly downloaded to the Flash memory card inserted in PCMCIA slot 0 or the designated destination device.

You can also copy the running configuration (located in DRAM) to a Flash memory card, as shown in the “Copying a Configuration File from RP DRAM to a Flash Memory Card” section on page 3-80.”

Step 3 To further verify that the configuration file was copied correctly to the Flash memory card in slot 0, enter the dir command:

Router# dir slot0:
-#-	-length-	-----date/time------	name
1	5200084	May 10 2002 19:24:12	gsr-p-mz.112-8

31215 May 10 2002 20:30:52 myfile1

46176844 May 10 2002 23:04:10 gsr-p-mz.112-8.1

51186 May 10 2002 16:56:50 myfile2

9197156 bytes available (11381148 bytes used) Router#

	Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
OL-11497-03		3-79