3-15
Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
OL-11497-03
Chapter3 Installing the Router
Connecting to the Console and Auxiliary Ports
Figure 3-8 GRP Console DCE and Auxiliary DTE Port Connections
Check your terminal documentation to determine the baud rate of the terminal you
plan to use. If your documentation does not specify settings, use the following
terminal settings: 9600 baud, 8 data bits, no parity, and 2 stop bits. You will need
an EIA/TIA-232 DCE console cable to connect the terminal to the console port.
Note To comply with Telcordia GR-1089 NEBS standard for electromagnetic
compatibility and safety, connect all console, auxiliary, and Ethernet interfaces
only to intrabuilding or nonexposed wiring or cabling. The intrabuilding cable
must be shielded and the shield must be grounded at both ends.
SLOT
-0
SLOT
-1
COLL
LINK
TX
RX
RJ-45
MII
RESET
AUX
EJECT
H10735
Modem
Console terminal
Auxiliary
port
DB-25 female
DB-25 male
Console
port
GRP