Chapter 4 Replacing Components

Replacing an I/O Module for a Cisco Nexus 5548 Switch

Se n d d o c u m e n t a t i o n c o m m e n t s t o n ex u s 5 k d o c s @ c i s c o . c o m .

Figure 4-4 Removing the I/O Module from the Chassis

1

1Pull the handle on the left fan module to completely remove the I/O module from the chassis.

239215

Step 7 Place the removed I/O module on the antistatic surface.

Step 8 On the remaining fan tray in the I/O module, loosen its captive screw so that it is no longer attached to the I/O module.

Step 9 Pull the fan tray out of the I/O module.

You are ready to install a replacement I/O module as explained in the “Installing a Fan Module” section on page 4-14.

Installing an I/O Module

To install an I/O module in a Cisco Nexus 5548 chassis, follow these steps:

Step 1 Align the replacement I/O module to the I/O module slot in the chassis and push the module all the way into the slot so that its two captive screws are aligned to their holes in the chassis.

Step 2 Tighten both captive screws to the chassis.

Step 3 Install both fan modules into the replacement I/O module (see the “Installing a Fan Module” section on page 4-14).

Cisco Nexus 5500 Platform and Cisco Nexus 5000 Platform Hardware Installation Guide

4-4

OL-15902-01

 

 

Page 114
Image 114
Cisco Systems 5000 manual Installing an I/O Module, Removing the I/O Module from the Chassis