Cisco Systems 5000 manual 2-16, 12 Installing the Slider Rails

Chapter 2 Installing the Cisco Nexus 5000 Series Switches

Installing the Switch

Se n d d o c u m e n t a t i o n c o m m e n t s t o n ex u s 5 k d o c s @ c i s c o . c o m .

1	Front rack-mount bracket	3	Rack-mount guides
2	Attach bracket with four M4 screws	4	Attach guide with two M4 screws

Step 2 Install the rack-mount guides on the switch as follows:

a.Position one of the rack-mount brackets against the side of the switch and align the screw holes as shown in Figure 2-11. Attach the bracket to the switch with two of the flat-head M4 screws.

b.Repeat with the other rack-mount bracket on the other side of the switch.

Step 3 Attach the slider rails to the rack (see Figure 2-12). Use two 12-24 screws or two 10-32 screws, depending on the rack rail thread type. For racks with square holes, insert the 12-24 cage nuts in position behind the mounting holes in the slider rails.

Note You must supply the 12-24 or 10-32 screws.

a.Repeat with the other slider rail on the other side of the rack.

b.Use the tape measure and level to verify that the rails are horizontal and at the same height.

Figure 2-12 Installing the Slider Rails

186412

Step 4 Insert the switch into the rack and attach as follows:

a.Using both hands, position the switch with the back of the switch between the front posts of the rack.

b.Align the two rack-mount guides on either side of the switch with the slider rails installed in the rack. Slide the rack-mount glides onto the slider rails, and then gently slide the switch all the way into the rack. As shown in Figure 2-9 on page 2-14, this step is the same as with the step for attaching the Cisco Nexus 5020 to the rack. If the switch does not slide easily, try realigning the rack-mount glides on the slider rails.

	Cisco Nexus 5500 Platform and Cisco Nexus 5000 Platform Hardware Installation Guide
2-16	OL-15902-02