Cisco Systems 5000 manual Replacing or Installing Power Supplies

Chapter 4 Replacing Components

Replacing or Installing Power Supplies

Se n d d o c u m e n t a t i o n c o m m e n t s t o n ex u s 5 k d o c s @ c i s c o . c o m .

Figure 4-7 Positioning the Module in the Cisco Nexus 5010 Chassis

273162

Replacing or Installing Power Supplies

The Cisco Nexus 5500 Platform switches and the Cisco Nexus 5000 Platform switches support two front-end AC or DC power supplies, but may be used with one power supply. The switches each require one power supply, but you can include a second power supply for power redundancy. If you use only one power supply, you must fill the second power supply slot with a blank module to maintain the designed airflow.

If you need to replace an existing power supply, follow the procedures that explain how to remove and install power supplies. If you are installing a new power supply where one did not exist before, follow the installation procedure.

Note The airflow direction must be the same for all power suply and fan modules in the chassis. You can order all modules with front to back airflow but you can alternatively order back to front airflow for the Cisco Nexus 5548UP switch modules. Back to front airflow modules have a black stripe.Make sure that all modules have either a black strip for back to front or no stripe for front to back.

This section includes the following topics:

•Removing a Power Supply, page 4-9

•Installing a Power Supply, page 4-11

•Wiring a DC Power Connector, page 4-12

Note You can replace a faulty power supply while the system is operating if the other power supply is functioning.

Cisco Nexus 5500 Platform and Cisco Nexus 5000 Platform Hardware Installation Guide

4-8 OL-15902-01