Cisco Systems 7401ASR manual Attaching the Cable-Management Bracket

Chapter 2 Rack-Mounting, Tabletop Installation, and Cabling

Installing the Router

Attaching the Cable-Management Bracket

Figure 2-4 Installing the Cable-Management Bracket

1

ENABLED

RX	CELLS	CARRIERALARM	TX
	RX	RX
			RX

57578 2

1

Cable-management bracket

2

M4 x 20-mm screw

Step 1 Align the cable-management bracket to the rack-mount bracket on the left side of the Cisco 7401ASR router.

Step 2 Using a Phillips screwdriver and the M4 x 20-mmscrew, thread and tighten the screw to the cable-management bracket.

This completes the procedure for installing the cable-management bracket on a Cisco 7401ASR router for a front rack-mount configuration. Go to the “Installing the Chassis in the Rack” section on page 2-9.

Installing Rack-Mount Brackets on the Rear of the Chassis

Figure 2-5 Attaching the Rack-Mount Brackets to the Rear of the Chassis

	D			R
	LE		LS	RIE	M
AB		EL		AR	AR
EN		XC	XC	AL
	R		R	RX

TX RX

2

ENHANCED ATM

1

50532

1

Rack-mount bracket

2

4screws, 8-18 x .37 in., for use with a 19-inch rack

4screws, 8 x .375 in., for use with a 21–23- inch rack

To install the rack-mount and cable-management brackets on a Cisco 7401ASR router for a rear rack-mount configuration, complete the following steps:

Step 1 Locate the threaded holes in the rear sides of the chassis.

Cisco 7401ASR Installation and Configuration Guide

2-8 OL-5419-01 B0