Step 7 For
Step 8 Reconnect all interface cables.
Installing Feature Cards
For detailed information on installing and connecting feature cards, see the Cisco AS5350XM and Cisco AS5400XM Universal Gateways Card Installation Guide.
You can access this document at Technical Support & Documentation > Product Support > Universal Gateways and Access Servers > Cisco AS5300 or Cisco AS5400 Series Universal Gateways > Install and Upgrade Guides.
Warning | The telecommunications lines must be disconnected 1) before unplugging the main power connector and/or 2) | |
|
| while the housing is open. Statement 89 |
|
|
|
|
|
|
Warning | Do not work on the system or connect or disconnect cables during periods of lightning activity. Statement 1001 | |
|
|
|
Note When you replace a feature card with a new feature card of the same type in the same slot, the system software recognizes the new trunk interfaces and brings them up automatically. If you replace the existing feature card with a new feature card of a different type, you must reconfigure the system. For configuration details, see the
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide.
Note The Cisco AS5350XM and Cisco AS5400XM universal gateways does not support the mixing of T1 and E1 feature cards in the same chassis. For more information about mixing WAN feature cards, see the Cisco AS5350XM and
Cisco AS5400XM Universal Gateways Card Installation Guide.
To install a feature card, follow these steps:
Step 1 Attach an
Step 2 Slide the feature card into the slot until the connector pins make contact with the carrier card backplane connector. (See Figure 14 and Figure 15.)
Figure 14 Installing a Feature Card in a Cisco AS5350XM Universal Gateway
0 | 1 | Rx Tx |
|
|
2 PRI |
ACT OK 
36816
11
