Cisco Systems AS5400XM Verifying the Group Interface Configuration, Gateway# show async status

Models: AS5400XM

1 68
Download 68 pages 41.48 Kb
Page 41
Image 41
Verifying the Group Interface Configuration

Step 4 Define the slot/port group range of the interface. The range that you specify depends on the number of asynchronous interfaces you have on your gateway. If your gateway has 108 asynchronous interfaces, you can specify group-range 1/1 1/107.

Gateway(config-if)# group-rangeslot/port slot/port

Building configuration...

Gateway(config-if)#

Step 5 Return to privileged EXEC mode:

Gateway(config-if)# Ctrl-Z

Gateway#

Tip To save the gateway configuration, save it to NVRAM. See the “Saving Configuration Changes” section on page 60.

Verifying the Group Interface Configuration

To verify your group interface configuration, enter the show interface async command in privileged EXEC mode:

Gateway# show interface async 4/0

Async4/00 is down, line protocol is down modem(slot/port)=4/0, state=IDLE dsx1(slot/unit/channel)=NONE, status=VDEV_STATUS_UNLOCKED Hardware is Async Serial

MTU 1500 bytes, BW 115 Kbit, DLY 100000 usec, reliability 255/255, txload 1/255, rxload 1/255

Encapsulation SLIP, loopback not set DTR is pulsed for 5 seconds on reset

Last input never, output never, output hang never Last clearing of "show interface" counters never

Input queue: 0/10/0/0 (size/max/drops/flushes); Total output drops: 0

Queueing strategy: weighted fair

Output queue: 0/1000/64/0 (size/max total/threshold/drops) Conversations 0/1/32 (active/max active/max total) Reserved Conversations 0/0 (allocated/max allocated) Available Bandwidth 86 kilobits/sec

5 minute input rate 0 bits/sec, 0 packets/sec

5 minute output rate 0 bits/sec, 0 packets/sec

0 packets input, 0 bytes, 0 no buffer

Received 0 broadcasts, 0 runts, 0 giants, 0 throttles

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort 0 packets output, 0 bytes, 0 underruns

0 output errors, 0 collisions, 0 interface resets

0 output buffer failures, 0 output buffers swapped out

0 carrier transitions

If you are having trouble, check for errors as well as local and remote addresses. Enter the show async status command in privileged EXEC mode:

Gateway# show async status

Async protocol statistics:

Int

Local

Remote

Qd

InPack

OutPac

Inerr

Drops

MTU

1/00

42.1.1.1

None

0

0

0

0

0

1500

1/01

192.168.10.100

None

0

0

0

0

0

1500

1/02

192.168.10.100

None

0

0

0

0

0

1500

1/03

192.168.10.100

None

0

0

0

0

0

1500

1/04

192.168.10.100

None

0

0

0

0

0

1500

1/05

192.168.10.100

None

0

0

0

0

0

1500

41

Page 41
Image 41
Cisco Systems AS5400XM quick start Verifying the Group Interface Configuration, Gateway# show interface async 4/0