Cisco Systems AS5400XM quick start Configuring Isdn PRI

0 C-bit Coding Violation, 0 P-bit Err Secs

0 P-bit Severely Err Secs, 0 Severely Err Framing Secs

0 Unavailable Secs, 0 Line Errored Secs

0C-bit Errored Secs, 0 C-bit Severely Errored Secs Total Data (last 32 15 minute intervals):

0Line Code Violations, 0 P-bit Coding Violation,

0C-bit Coding Violation, 0 P-bit Err Secs,

0P-bit Severely Err Secs, 0 Severely Err Framing Secs,

0Unavailable Secs, 0 Line Errored Secs,

0C-bit Errored Secs, 0 C-bit Severely Errored Secs

Configuring ISDN PRI

Channelized T1 ISDN PRI offers 23 B channels and 1 D channel. Channelized E1 ISDN PRI offers 30 B channels and

1D channel. Channel 24 is the D channel for T1, and channel 16 is the D channel for E1. ISDN provides out-of-band signaling using the D channel for signaling and the B channels for user data.

For a complete description of the commands mentioned in this section, see the Cisco IOS Dial Technologies Configuration Guide, which is available online. You can access this document at Technical Support & Documentation > Product Support > Cisco IOS Software > Cisco IOS Software Release you are using > Configuration Guides.

Request PRI Line and Switch Configuration from a Telco Service Provider

Before configuring ISDN PRI on your Cisco universal gateway, you must order a correctly provisioned ISDN PRI line from your telecommunications service provider.

This process varies from provider to provider both nationwide and internationally. However, some general guidelines apply:

•Determine whether the outgoing B channel calls are made in ascending or descending order. The Cisco IOS software default is descending order; however, if the switch from the service provider is configured for outgoing calls made in ascending order, the universal gateway can be configured to match the switch configuration of the service provider.

•Ask for delivery of calling line identification. Providers sometimes call this CLI or automatic number identification (ANI).

•If the gateway will be attached to an ISDN bus (to which other ISDN devices might be attached), ask for point-to-multipoint service (subaddressing is required) and a voice-and-data line.

Configure ISDN PRI by following these steps:

Step 1 Use the enable command and password to enter privileged EXEC mode. You are in privileged EXEC mode when the prompt changes to Gateway#.

Gateway> enable

Password: password

Gateway#

Step 2 Enter global configuration mode. You are in global configuration mode when the prompt changes to Gateway(config)#.

Gateway# configure terminal

Enter configuration commands, one per line. End with CNTL/Z.

Gateway(config)#

Step 3 Select a service provider switch type (see Table 5) that matches your service provider switch:

Gateway(config)# isdn switch-typeswitch-type

45