Cisco Systems CIVS-IPC-2630V manual Mounting with a Conduit Base, Procedure

Chapter 2 Getting Started

Installing the Cisco Video Surveillance 2630 IP Dome

Mounting with a Conduit Base

You can mount the 2630 IP dome with an optional conduit base (CIVS-IPCA-1006=) in situations where you cannot cut a hole through a surface for cables or where cables run through a small hole in a surface.

To mount the IP camera with a conduit base, perform the following steps:

Note When you disassemble the IP dome for mounting as described in these steps, make sure to remove any protective packing material that is installed between components.

Procedure

Step 1 Remove the dome assembly by unscrewing the three security TORX screws and pulling the dome away from the base plate (see Figure 2-2).

Use the TORX screwdriver that is provided with the IP dome to unscrew these screws.

Figure 2-2 Disassembling the 2630 IP Dome Components

1

2

3

4

5

6

1

2

Base plate

Camera unit

Cisco Video Surveillance 2630 IP Dome User Guide

2-4 OL-24130-02