Cisco Systems CIVS-IPC-2630V manual Attaching the Base Plate to the Conduit

Chapter 2 Getting Started

Installing the Cisco Video Surveillance 2630 IP Dome

Step 4 Attach the base plate to conduit with 4 screws, provided, as shown in Figure 2-10.

Make sure that the gasket is clean and in place.

Figure 2-10 Attaching the Base Plate to the Conduit

1

2

3

3

Pendant

Conduit base

Gasket

Base plate

Step 5 Put the an category 5 or higher Ethernet cable through the appropriate cable entry hole in the conduit base and the opening in the base plate and connect the cable to the LAN port on the IP dome (see Figure 1-1 on page 1-3).

Caution Do not lift the IP dome by the Ethernet cable.

Step 6 Put the power cable through the appropriate cable entry hole in the conduit base and the opening in the base plate and connect it to the power input on the IP dome (see Figure 1-1 on page 1-3).

To connect a power cable, use a flat-head screwdriver to depress the brown tabs on the power input and connect bare positive, negative, and ground wires as shown on the label that is affixed to the IP dome.

Step 7 (Optional) Connect an external speaker, microphone, or both to the Y cable, then connect the Y cable to the audio port on the IP dome.(see Figure 1-1 on page 1-3). The Y cable that is included in the optional audio/video cables accessory kit can be purchased from Cisco (Cisco part number CIVS-IPCA-1017=).

Each device connects to the audio cable through a standard 3.5 mm mini phone jack. A speaker connects to the green jack, which is labeled “Audio Out.” A microphone connects to the pink jack, which is labeled “Audio In.”

Step 8 (Optional) Use the GPIO ports to connect external devices that trigger alarms (connect through alarm input ports) or respond to alarms (connect through alarm output ports).

See Figure 1-1 on page 1-3.

	Cisco Video Surveillance 2630 IP Dome User Guide
2-12	OL-24130-02